Hello,
at the moment we have capacity check method 5 in use. But it doesn`t have all the features we need.
Therefore we want to use capacity check method 6(Usage check based on material plus SUT) to achieve that the same material can be stored in the same storage bin and increases capacity as well as it is a add of the same material (if settings made in management view).
In the past we have used capacity check method 5; the problem is here that the capacity increases one time. Then you can put the same material to the storage bin all the time without increasing capacity.
If I want to use the Capacity Check Method 6 I have to fill in Capacity consumption (field MLGN-MKAPV in Warehouse Management (material management) view 1). Otherwise this error message orrurs: Message no. L3066: "Not all the data has been defined for the capacity check (material 03-154.803)"
Is it possible to avoid message L3066?
Example: Settings WM2 view: "10" (MLGN-LHMG1) "ST" pro "Ls7" (mlgn-LETY1)
At the moment I fill in 0,001 to field MLGN-MKAPV. Per
SUT (storage unit type) is increased then the capacity (for example, 10 for example in Ls7)
and additionally by 0,001 per material.
This is the desired result with the exception that 0,001 should not be added.
If I get a new material receipt on this storage bin (same material, again 10 ST) then the used capacity on the storage bin rises from 10,01 to 20,02..
The utilization rises, too.
The only problem is that the remaining capacity every time decreases by 0.001 per material. I would be
happy if I could turn off the message L3066. Then I could set MLGN-MKAPV to 0.
Is this possible and is this even the right approach?
I hope you can help me,
Sincerely yours